5 000 t公务船调距桨桨叶数选型研究

针对国内外调距桨桨叶数选型依靠经验为主，对不同桨叶数对推进器整体性能的影响始终缺乏定量分析的现状，以某5 000 t公务船为目标船型，通过调距桨分别配置不同的桨叶数，分析不同桨叶数对目标船型综合性能的影响。总结了公务船调距桨桨叶数选型的方法，归纳了不同叶数调距桨的优劣，可为后续新造船桨叶数的选取提供参考。     

Numerical evaluation and the effects of geometrical and operational parameters on thermal performance of the shell and double coil tube heat exchanger

Heat exchangers are extensively used in various industries. In this study, the impact of geometric and flow parameters on the performance of a shell and double helical coil heat exchanger is studied numerically. The investigated geometric parameters include external coil pitch, internal coil pitch, internal coil diameter, and coil diameter. The influences of considered geometrical parameters are analyzed on the output temperature of the hot and cold fluid, convective heat transfer coefficient, pressure drop, and average Nusselt number. Water is considered as working fluid in both shell and tube. As an innovation, double helical coils are used instead of one in the heat exchanger. To compare the obtained results accurately, in each section, the heat transfer area (coil outer surface) is kept constant in all models. The results show that the geometrical parameters of double helical coils significantly affect the heat transfer rate.     

严寒地区SiO2气凝胶玻璃窗传热分析

建立了二氧化硅(SiO_2)气凝胶中空玻璃窗传热数值模型,采用有限体积法分析了二氧化硅气凝胶厚度和位置对严寒地区玻璃窗传热的影响。结果表明:二氧化硅气凝胶厚度增加,能够提高玻璃窗内表面温度,降低其热流密度。二氧化硅气凝胶厚度为20 mm时,玻璃窗内表面热流密度为67.5 W/m~2。二氧化硅气凝胶位于室内侧能够更有效地减少建筑能耗,其总能耗为60 120 W。     

Design and Analysis of a Single-Stage Transonic Centrifugal Turbine for organic Rankine cycle(ORC)

The recovery of low temperature heat sources is a hot topic in the world.The ORC system can effectively use the low temperature heat source.As its main output device,the performance of the turbine is very important.The single stage transonic turbine has the characteristics of small size and large output power.In this paper,the complete design process of a transonic centrifugal turbine with R245fa in low working temperature condition is introduced.At the design conditions,the shaft power and the wheel efficiency of the centrifugal turbine can reach 1.12 MW and 83.61%,respectively.In addition,a thermodynamic ORC cycle is presented and the off-design conditions of the turbine and its influence on the system are studied in detail.The results obtained in the present work show that the single-stage transonic centrifugal turbine can be regarded as a potential choice to be applied in small scale ORC systems.     

基于模糊评价理论对层燃工业锅炉综合性能的研究与分析

为有效地平衡锅炉效率与排放之间的关系,通过分析锅炉的能效指标,建立了结合效率因素、燃料管理因素和环境因素等的能效评价指标体系。采用组合赋权法确定权重,建立了锅炉系统模糊综合评价模型,并利用该模型对山西大同某层燃蒸汽锅炉进行了综合能效评价与分析。结果表明:锅炉的综合评级得分为0.59,燃料设备因素指标得分仅为0.19。该锅炉热效率虽然达到了设计要求,但锅炉飞灰含碳量偏大,同时过量空气系数为2.34,远大于设计标准1.65。综合分析其原因是漏风过大,该分析结果与现场热力测试实验数据相符合。     

Three‐dimensional computational comparison of mini pinned heat sinks using different nanofluids: Part one—the hydraulic‐thermal characteristics

The hydraulic‐thermal characteristics of 3D pinned heat sink designs have been numerically compared as the first part of a three‐part investigation. Five different pin geometries (circular, square, triangular, strip, and elliptic pins) and an unpinned heat sink with three types of nanofluids (Al₂O₃–H₂O, SiO₂–H₂O, and CuO–H₂O) are considered for laminar forced convection. The range of Reynolds number is from 100 to 1000, and volume fractions vary between 0% and 5%. The finite volume method is employed to solve the Navier–Stokes and energy equations by employing a SIMPLE algorithm for a computational solution. Three parameters are presented—the Nusselt number, the bottom temperature, and the hydrothermal performance of the heat sink with pressure drop data. The findings indicated that the overall hydrothermal performance of elliptic‐pinned (EP) heat sinks produces the most substantial value of 3.10 for pure water. For different nanofluids, the SiO₂–water nanofluids with EPs have the most significant hydrothermal performance. Also, this factor is enhanced with an increase in nanofluid concentration up to nearly 3.34 for 5% of SiO₂–water. Consequently, applying the elliptic‐pinned heat sinks is recommended with pure water for considering an increase in the pressure drop, with 5% of SiO₂–water nanofluids, regardless of an enlargement of pressure drop for heat‐dissipation applications.     

Experimental investigation of Al2O3–MgO hot hybrid nanofluid in a plate heat exchanger

Exergy–energy analysis of the plate heat exchanger is experimentally performed with different Al₂O₃–MgO hybrid nanofluid (HyNf) as a hot fluid. There were six combinations of fluids, namely, deionized (DI) water, ethylene glycol–DI water brine (1:9 volume ratio), propylene glycol–DI water brine (1:9 volume ratio), base fluids and their respective Al₂O₃–MgO (4:1 particle volume ratio) HyNfs of 0.1% total volume concentration. The effects of different flow rates and hot inlet temperatures on the heat transfer rate, heat transfer coefficient, pump work, irreversibility, and performance index (PI) are investigated. It is witnessed that the heat transfer rate, heat transfer coefficient, pump work, and irreversibility enhances with the flow rate and nanoparticle suspension. While the PI declines with a rise in the flow rate, the heat transfer rate, heat transfer coefficient, PI, and irreversibility rise up maximum for MgO–alumina (1:4) DI water HyNf upto 11.8%, 31.7%, 11.1%, and 4.05%, respectively. The pump work enhances upto 1.6% for MgO–alumina (1:4)/EG–DI water (1:9) HyNf.     

石蜡与石蜡/膨胀石墨熔化性能的实验研究

为改善相变储能过程中石蜡(PA)的熔化性能，向PA中添加少量膨胀石墨(EG)制备了4种配比的石蜡/膨胀石墨复合相变材料(PA-EG)。通过热物性分析筛选出合适配比的PA-EG，并对其和PA在水平管壳式相变储能单元中的熔化过程进行了实验研究。根据相变材料的温度场变化以及加权法计算得到的熔化分数变化，对比分析了添加EG前后PA的熔化性能，并探究了加热温度对相变材料熔化性能的影响。结果表明，PA-EG3的热导率比PA高了7倍，且两者的相变温度和潜热相差不大。PA-EG3熔化过程中的自然对流效应弱于PA，但是较高的热导率能够显著改善相变储能单元中下部的熔化，使得其整体熔化速度快于PA。当加热温度为80℃时，PA-EG3的熔化过程比PA缩短了78.16%。此外，降低加热温度会使PA和PA-EG3的完全熔化时间都显著增加，但相同条件下PA-EG3的增加幅度更小。     

高效液相色谱-串联质谱法检测新鲜蔬菜中的氯酸盐残留

目的建立高效液相色谱-串联质谱(high performance liquid chromatography-tandem mass spectrometry,HPLC-MS/MS)检测新鲜蔬菜中氯酸盐的分析方法。方法称5 g样品,分别用5 mL乙腈提取2次,合并提取溶液,定容,无需净化步骤,选择Hypercarb多孔石墨化碳色谱柱作为固定相,1%乙酸-水溶液和1%乙酸-甲醇溶液作为流动相进行梯度洗脱色谱分离,然后采用电喷雾离子化三重四极杆串联质谱测定。结果氯酸盐在0.0025～0.2 mg/L范围内峰面积与质量浓度的线性关系良好,相关系数(r~2)大于0.999;平均回收率为72.9%～100.2%,相对标准偏差为1.8%～6.2%,氯酸盐的定量限为0.01 mg/kg。结论该方法简单快速、准确可靠、成本低廉,适合新鲜蔬菜中氯酸盐的测定。     

低阶煤热解条件对高炉喷吹半焦燃烧性能及动力学特性的影响

采用热重分析法研究了不同热解条件下半焦的燃烧性能和动力学特征，利用Ozawa法求取动力学参数。结果表明，热解温度越低、保温时间越短时，半焦的燃烧性能越好；热解升温速率对半焦燃烧过程的反应程度影响不大；粒度越大，燃烧性能差异性越明显。热解温度对半焦燃烧性能影响较大，550℃是本研究中制备高燃烧反应性半焦的适宜热解温度。两种不同粒度原煤制得的半焦均随转化率增大，活化能减小。1~3 mm原煤在热解温度为550℃时所得半焦在燃烧过程中符合反应级数模型，化学反应为限制性环节，反应最概然机理函数为f(α)=(1–α)2。